I going to build a new motor on a Merlin III 85110 pro block. The block has 10.200" deck height from the beginning but are now deckt to 10,160" with a o-ring groove and the bore is now 4.635" it also has billet splayed caps. Its honed with torque plates to by the chop







Old motor
Old motor
motor
motor
It’s going to be massive with a Lunati 4.500" crank
And a set of Eagle 6,700"rods
So a bigger blower is required so i bought a Mooneyham 10-71 and a Littlefield square port manifold for a 10.200” with a sfi burst panel that feed my
Brodix BB-2X aluheads

and a Enderle birdcatcher to top it of. In the bottom ther is a Enderle 110 pump

Meziere starter, electric waterpump, alu pan and a BTE flexplate to match my BTE Power Glide

So a bigger blower is required so i bought a Mooneyham 10-71 and a Littlefield square port manifold for a 10.200” with a sfi burst panel that feed my
And a set of Eagle 6,700"rods
It’s going to be massive with a Lunati 4.500" crank
I going to build a new motor on a Merlin III 85110 pro block. The block has 10.200" deck height from the beginning but are now deckt to 10,160" with a o-ring groove and the bore is now 4.635" it also has billet splayed caps. Its honed with torque plates to by the chop







Brodix BB-2X aluheads

and a Enderle birdcatcher to top it of. In the bottom ther is a Enderle 110 pump

Meziere starter, electric waterpump, alu pan and a BTE flexplate to match my BTE Power Glide